Sky-watcher Multi-Purpose Computerized Mount Manuel d'utilisateur télécharger pdf (Page 5)

TheAllViewmountcomescompletelypre-assembledandcanbeoperationalinamatterofminutes.Themountisconvenientlypackaged

in one reusable shipping carton that contains all of the following accessories:

• AllViewmount

• SynScanhandcontrol

• Mountingbracket(in4pieces)

• Steeltripod

• Tripodaccessorytray

• Camerashuttercable(formostCanonRebelcameras)

• RS-232cable

Assembling the AllView™ Mount

StartbyremovingtheAllViewmountfromitsshippingcartonandremovingalloftheaccessoriesfromtheirindividualboxes.

Remembertosaveallofthecontainerssothattheycanbeusedtotransportorstorethemount.

Tripod and Mount Setup

The AllView mount is shipped with the tripod already attached. To set up the mount and tripod:

1. Slowlyloosentheheightadjustmentscrewsandgentlypulloutthelowersectionofeachtripodleg.Tightenthescrewstohold 

 thelegsinplace,asshowninFig. 1.

2. Spreadthetripodlegsaparttostandthetripodandmountupright,asshowninFig. 2.

Assembly

Fig. 1

3. Adjusttheheightofeachtripodleguntilthemountisproperlyleveled.Thereisalevelingbubbleprovidedonthemount’sbase 

 thatyoumayusetocheckthemount’sleveling.Note:thetripodlegsmaynotbeatsamelengthwhenthemountisleveled.

Fig. 2

1 2 3 4 5 6 7 8 9 10 ... 43 44

Pas de commentaire

Sky-watcher Multi-Purpose Computerized Mount Manuel d'utilisateur Page 5